- Create a new partition called UK_PTN_PSTN_CLID_RESTRICT
- Create a new CSS called UK_CSS_FULL_RESTRICT_CLID and insert the new PTN above and whatever other PTN's you previously have to allow internal and external calling (except maybe any previous PTNs you have that point to a gateway)
- Create a new Route Pattern i.e 9.@ and set the partition to be the newly created PTN. Also set the Calling Party Transform Mask and Calling Name Presentation to "Restricted". This route pattern will block CLID outbound.
- On which ever UDP's or Device's you wish to restrict CLID use the newly created CSS on the line.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...