Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CLID from H323 gateway with CM 6.0.1

Hi

I am using a router with a PRI in it setup as a H323 gateway for PSTN access. It works fine but when a user answers an incoming call the phones don't display the calling number.

I can see that BT are sending the CLID (debug ISDN Q931) but the 7900 phones don't get it.

Is there a setting in CM 6.0.1 or in the IOS config that needs to be changed to enable CLID on incoming calls ?

Thanks

Pat

1 REPLY
New Member

Re: CLID from H323 gateway with CM 6.0.1

Just to follow up on this. The PSTN provioder (BT) had disabled caller id ! When I initially tested it Caller ID was working but at some stage they have disabled it and it no longer shows up in the Q931 debug. So it's not a Cisco issue.

114
Views
0
Helpful
1
Replies
CreatePlease login to create content