When calling out BRI, I want individual numbers displayed as caller id. For incoming calls, I want to display the caller id on the phone. So I have a rule to translate the outgoing calling number, but the main office number 6321000 is displayed as the calling number. Incoming caller-id is shown as 'unknown'. 9 is PSTN access code. Extensions are 10xx.
voice translation-rule 9
rule 1 // /1/
voice translation-rule 10
rule 1 /^10/ /632&/
voice translation-rule 11
rule 1 /^9/ //
rule 2 /^111$/ /111/
voice translation-profile DID_TO_EXT
translate called 9
voice translation-profile OUT-GOING
translate calling 10
translate called 11
Please point out the errors I have made. Or give some reference.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...