I setup client matter codes for one of our locations, the issue is after the CMC is entered the call takes approximately 15 seconds to complete. Is there a way to make this process quicker, such as entering # or is there a timer I can adjust? Call Manager version is 8.5.1
Yes, the # key seemed to route the call instantly, I asked the customer to test earlier today and they said it didn't work, I setup IPC and it clearly does work. Not sure what the problem was. T302 also works if they don't happen to hit the # key. Thanks for your help.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...