Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

clock calendar-valid invalid command error

Hi techs,

Hopefully this is a simple issue

Want to resolve error of when updating cisco phone configuration files via create cnf-files I get error of 

%Error deleting flash:SEPDEFAULT.cnf (No such file or directory)
%Error deleting flash:XMLDefault.cnf.xml (No such file or directory)

Is a file in flash: called xmldefault7912.cnf but none as named above

Upon searching via google for introduction of clock calendar-valid command..cisco site shows IOS 10.0 onwards for which I have 12.2 via cme 3.3

Upon searching for reasoning of %Error deleting flash:SEPDEFAULT.cnf (No such file or directory), a Cisco site http://www.oocities.org/manojkreddyutl/cisco/150.htm

leads me to run the clock calendar-valid command but I get error of invalid command error under conf t

I have ntp master set though

Please advise further

Thanks in advance again.. :) :) 

 

2 REPLIES
Green

Hi JohnCan you make sure you

Hi John

Can you make sure you have the following commands in your config

!
tftp-server flash:SEPDEFAULT.cnf
tftp-server flash:XMLDefault.cnf.xml
!

Also the command "clock calendar-valid" is hardware dependant
If your router is old then it most likely wil not
take this command

Regards
Alex

Regards, Alex. Please rate useful posts.
New Member

Hi Alex,Thanks for your reply

Hi Alex,

Thanks for your reply. Tried your resolution to no affect

Below is the message response

cme_router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
cme_router(config)#telephony-service
cme_router(config-telephony)#create cnf-files
CNF file creation is already On
Updating CNF files

%Error deleting flash:SEPDEFAULT.cnf (No such file or directory)
%Error deleting flash:XMLDefault.cnf.xml (No such file or directory)
CNF files update complete

cme_router(config-telephony)#

57
Views
0
Helpful
2
Replies
CreatePlease to create content