Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Clocking issues PRI + Data t1s on a VWIC2-2MFT-T1/E1

I have a Cisco 2821 that is getting two different T1 clocks from different providers. The Cisco 2821 has a VWIC2-2MFT-T1/E1 wic card. 1 t1 on the card is data, 1 is a voice PRI.

I am trying to figure out this proper configuration for this, I was thinking that this configuration would be correct:

network-clock-participate wic 1

network-clock-select 1 T1 0/0/1

!

controller T1 0/0/0

framing esf

clock source line independent

linecode b8zs

channel-group 0 timeslots 1-24

description MPLS Circuit

!

controller T1 0/0/1

framing esf

linecode b8zs

pri-group timeslots 1-24 service mgcp

description Voice PRI Circuit

!

IT is my understanding that you need to have network-clock-participate ON when using a voice gateway. The problem with the above config is this:

(config-controller)# clock source line independent

%Please remove network-clock-participate wic 0 first

How should this be configured?

3 REPLIES
Hall of Fame Super Gold

Re: Clocking issues PRI + Data t1s on a VWIC2-2MFT-T1/E1

Hi, in most countries, properly set networks are synchronous to the same master source, so is not said you necessarily need independent clocking. So check first if you're getting slips with normal clocking.

Then in your example the wic in network-clock-participate should be 0, not 1.

Finally if you want to try independent clocking, follow router advice and remove the wic-pariticpate first.

Re: Clocking issues PRI + Data t1s on a VWIC2-2MFT-T1/E1

I can try again at later.. i was using wic 0, not wic 1, that was a typo.

Re: Clocking issues PRI + Data t1s on a VWIC2-2MFT-T1/E1

I have also run into this issue when trying it without network-clock-participate

# pri-group timeslots 1-24 service mgcp

%Please configure network-clock-participate wic 0 first

Perhaps, having network-clock-participate and both set to clock source line, no t1s set to independent is the key? I can not test this at the moment

434
Views
0
Helpful
3
Replies