11-07-2013 01:58 AM - edited 03-16-2019 08:16 PM
When I call from CM to Avaya call established but no voice in both destination are send.
I have no direct access to Avaya.
Can any explane from Cisco side can I determine remote destination ip in traces or other loggs?
remote destination is not Avaya H.323 gateway adress ...
thank you all
11-13-2013 09:26 PM
Hello!
>What did you do for this to start working?
unfortunatelly I don't have access to avaya. Responsibility people take some changes but i don't know what it was...
Call from CM to Avaya is not working
On phone call seems started but but no voice in both directions
I attached trace from CM
11-13-2013 11:36 PM
Chernyakov,
After looking at the traces, the problem is the same as before, there is no H245 negotiation between CUCM and Avaya for this call. whatever they did to fix the Avaya to CUCM, they need to do it for CUCM to Avaya too
Please rate all useful posts
"opportunity is a haughty goddess who waste no time with those who are unprepared"
11-15-2013 12:29 AM
Hello!
Thank you very much for Assistance!
The ussue was resolved by checking "MTP point required " on CM gateway configuration page...
Thank very much again!!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide