Re: CM 5.1 Attendant Console Algorithm with Always Route
If you use Circular Hunting, the Always Route number only kicks in when the "Maximum Queue Size" or "Maximum Hold in Queue time" are exceeded. Have a look at this good older doc that still applies;
If you want Cisco TCD to queue calls when all attendants in a hunt group are busy, check the Enable Queuing check box. To complete the call-queuing configuration, enter values in the Queue Size and Hold Time (in Seconds) fields.
Choose the routing option that you want to use for the pilot point that you choose in the Pilot Points drop-down list box. Available options include
This field specifies the number of calls that are allowed in the queue. If the queue is full, Cisco TCD routes calls to the "always route" hunt group member that is specified on the Hunt Group Configuration window. If you do not specify an always route member, Cisco TCD drops the call when the queue size limit is reached.
The default specifies 32.
Hold Time (in Seconds)
This field specifies the maximum amount of time (in seconds) that Cisco TCD keeps a call in the queue.
If a call remains on hold for the number of seconds entered in this field and you configured an "always route" hunt group member on the Hunt Group Configuration window, Cisco TCD sends the call to the always route member that is specified on the Hunt Group Configuration window. If you do not configure an always route member, the call remains in the queue until an attendant becomes available.
Enter 0 in this field to keep calls in the queue until an attendant becomes available.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...