We had two Nortel BCMs working with a CM platform for a couple of years. However, about two months ago calls between the locations started getting dead air. The calls connect and pass caller ID without issue. It was not reported for a long time, so it is unclear what if anything was changed to break it.
Does anyone know of a working configuration to make these work together?
We currently have the BCMs defined as H.323 gateways in CM and the CM defined as an H.323 trunk in the BCM.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.