Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

CM calling CME/CUE via VOIP

I have a customer with a CM site and a CME/CUE site. When I call from the CM site to the CME/CUE via VOIP I get a fast busy when it hits the call-forward noans timer. I imagine I am missing a dial-peer somewhere, but looking for some direction of what would be needed to make this scenerio work. Intrasite calls work fine, just leaving a VM if the CM is calling the CME side.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: CM calling CME/CUE via VOIP

This is likely a transcoding issue. When calls get forwarded to CUE they are changing Codec from g729r8 to g711. You need to register a sccp transoder to the cme to perform this function for you.

Here is an example

http://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/design/CP_CIPExpress/cipce15.html#wp1012080

1 REPLY
New Member

Re: CM calling CME/CUE via VOIP

This is likely a transcoding issue. When calls get forwarded to CUE they are changing Codec from g729r8 to g711. You need to register a sccp transoder to the cme to perform this function for you.

Here is an example

http://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/design/CP_CIPExpress/cipce15.html#wp1012080

319
Views
0
Helpful
1
Replies
CreatePlease to create content