Central site CM with many remote sites. Currently all phones are registered to the Central CM with CME as SRST at the remote sites. Is there a way to have the phones register to CME as primary with CM as secondary but still do all the programming from CM at the central site? Rational is that the remote sites have MPLS links that go down on occasion for a few minutes at a time. The desire is to not have the phones have to re-register whenever the link is broken to Central CM.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...