CM Telephony Trigger Configuration misses parameters for Dialog Groups
How do I assign Primary and/or Secondary Dialogue Groups on a CM Telephony Trigger, so that I can use ASR & TTS? In IP-IVR v.4.0(1), in the area of jtapi trigger configuration, there were parameters to be set for the Dialog Groups.
Now, on Unified IP-IVR v.5.0(2), in the Unified CM Telephony Trigger Configuration Area, there are no parameters for the Dialog Groups. Where do i assign a trigger with a specific dialog group, such as an ASR dialog group?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...