Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

CM4.1.3 to 6.1.2 migration

Hello,

I've successfuly installed CM6.1.2 on new hardware (while leaving existing pub/sub intact)using dma and registered the lics. How do i start using the new server? I tried changing the ip address on one of my 7940's to point to the new server with no luck. I've read articles about post migration steps and lots of posts in here about upgrades/migations but i can't seem to find anything about how to proceed with a "swing migration". Any help is appreciated.

Thanks,

Marc

4 REPLIES
Cisco Employee

Re: CM4.1.3 to 6.1.2 migration

has the feature license been loaded?

Are all the services running??

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: CM4.1.3 to 6.1.2 migration

Hi,

yes the feature lic has been loaded and the services are running.

Thanks

New Member

Re: CM4.1.3 to 6.1.2 migration

Hi,

you say you have registered the licenses. Which licenses do you mean ?

Do you have any DLU's showing in the License Manager ?

Cheers,

Matt

New Member

Re: CM4.1.3 to 6.1.2 migration

Hi,

I entered the PAK number here https://tools.cisco.com/SWIFT/Licensing/PrivateRegistrationServlet?FormId=806 and cisco emailed me a lic which i uploaded to the new cm6 server. It shows i have 632 authorized and 614 used and 2 license servers authorized. Thanks again for your help.

-Marc

114
Views
0
Helpful
4
Replies
CreatePlease to create content