I would like to connect Exchange 2k7 with CM4.1. Microsoft doesn't support it in a production environment. My question is, what solution can I use as maybe a VOIP gateway between Exchange and CM4.1 to allow this to work? I have seen implementations of Asterisk but it only uses SIP over UDP and Exchange uses SIP over TCP. Others have stated OpenSER "Sip Express Router" works. Upgrading to CCM 5.0 is not an option at the moment.
What should I use as a solution to bridge CCM 4.1 with Exchange 2k7 and is anyone using this solution in production?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...