Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CM5.1 MCS 7845H NIC Teaming

How to setup NIC Teaming on MCS7845H for CM5.1?

1 REPLY
New Member

Re: CM5.1 MCS 7845H NIC Teaming

Here is a link that show how:

http://www.ciscotaccc.com/kaidara-advisor/voice/showcase?case=K49023175

In order to enable NIC teaming, complete these steps:

Secure shell (SSH) or log on to the console directly.

Enable it from the command line on the server.

Set network NIC failover enable.

Reboot the cluster.

Issue the show status command.

Issue the show network failover command.

Note: NIC teaming is only supported for fault tolerance and not load balancing.

133
Views
0
Helpful
1
Replies
CreatePlease to create content