Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

CME-3 fxo ports but can only make 1 O/B call

Hello. The router has 3 fxo ports but only able to make 1 call outbound at a time. The caller will not getting anything, just disconnects.

I have verified all the ports and pots lines by shutting each one down and able to complete calls out of all three.

When I do a show voice port sum. I see the second voice port go offhook but the call does not complete. And in the debug I see disconnect cause=28.

I have also tried using a trunkgroup instead of preferences on the dial-peers. Here is the voice port and dial-peer config.

voice-port 0/0/0

supervisory disconnect dualtone

pre-connect

pre-dial-delay 2

timeouts call-disconnect 5

timeouts wait-release 5

timing hookflash-out 250

connection plar opx 281

caller-id enable

!

voice-port 0/0/1

supervisory disconnect dualtone

pre-connect

pre-dial-delay 2

timeouts call-disconnect 5

timeouts wait-release 5

timing hookflash-out 250

connection plar opx 282

caller-id enable

!

voice-port 0/0/2

supervisory disconnect dualtone

pre-connect

pre-dial-delay 2

timeouts call-disconnect 5

timeouts wait-release 5

timing hookflash-out 250

connection plar opx 283

caller-id enable

!

voice-port 0/0/3

supervisory disconnect dualtone pre-connect

pre-dial-delay 2

timeouts call-disconnect 5

timeouts wait-release 5

timing hookflash-out 250

connection plar opx 281

caller-id enable

!

dial-peer voice 3 pots

description ** FXO pots dial-peer **

preference 1

destination-pattern 91..........

port 0/0/3

forward-digits 11

no sip-register

dial-peer voice 7 pots

description ** FXO pots dial-peer **

preference 2

destination-pattern 91..........

port 0/0/1

forward-digits 11

no sip-register

3 REPLIES
Hall of Fame Super Gold

Re: CME-3 fxo ports but can only make 1 O/B call

Configure hunt-group for the fxo ports, and reference it instead of a port in a single DP> That is the recommended mode of operation.

Re: CME-3 fxo ports but can only make 1 O/B call

You've got something else going on here, but it's hard to tell from partial description/debug.

If you can post the full debugs and show run we may be able to determine the problem.

Suspects: num-exp, translation patterns, dial peers you're not expecting, max-conn, etc

-nick

Bronze

Re: CME-3 fxo ports but can only make 1 O/B call

Thanks for the help.

I'm out of office right now and can use the tools, since vpn is down. Don't have the debugs either, sorry. Would have to post that tomorrow.

Thanks.

256
Views
0
Helpful
3
Replies
CreatePlease to create content