While installing CME for a small branch I have run into a problem with the hunt group feature. This branch doesn't have a receptionist and they don't want to use ACD.
I've programed a sequential hunt group with 6 numbers. I set CFA on the main number to the hunt group pilot number. When I dial the main extention or the hunt group pilot extention all I get is a busy signal. I'm sure I'm missing something simple here, and I have gone cross-eyed from reading the documentation.
Hopefully some one can point out the eror of my ways.
Try removing the "preference" commands from the ephone-dns. This command comes into play when you have multiple ephone-dns with the same number or multiple dial peers with the same destination pattern. The default preference is 0 so configuring higher preferences may be causing your problem.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...