Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CME 4.0 overlay not ringing phones

Hi

I have 6 phones with their main line being their DDI. The second line is

an overlay line. When the first call comes in phone A answers. When the second call comes into the same number the call only shows on phone A and doesn't ring on the other 5

phones. If I dial the number internally then the second call rings on the 5 phones.

IOS - 12.4(13r)T

Basically what I have is

ephone 2

mac-address xxxx.xxxx.xxxx

type 7965

button 1:2 2o23,26,27,28,29,30

!

!

!

ephone 3

mac-address xxxx.xxxx.xxxx

type 7965

button 1:3 2o23,26,27,28,29,30

!

!

!

ephone 4

mac-address xxxx.xxxx.xxxx

type 7965

button 1:4 2o23,26,27,28,29,30

!

!

!

ephone 5

mac-address xxxx.xxxx.xxxx

type 7965

button 1:5 2o23,26,27,28,29,30

If anyone has any ideas it would be much appreciated.

Thanks

4 REPLIES
Community Member

Re: CME 4.0 overlay not ringing phones

Can you provide the details of sh run, sh tech

Hall of Fame Super Gold

Re: CME 4.0 overlay not ringing phones

Hi,

before CME 4.3, calls to a shared DN thta has a call active, rings only on the phone that has the first call.

The workaround is to set for the shared DN, "huntstop channel" and "call forward busy" in chain for all the shared DNs.

Note, you may want to use "c" and not "o" as button command, because that gives you audible call waiting tone, while "o" doesn't.

Hope this helps, please rate post if it does!

Community Member

Re: CME 4.0 overlay not ringing phones

I applied the huntstop channel command a few days ago and it sorted the problem. Forgot to update the post.

Thanks for the replys

Hall of Fame Super Gold

Re: CME 4.0 overlay not ringing phones

You are welcome. Please rate useful posts with the scrollbox below.

210
Views
0
Helpful
4
Replies
CreatePlease to create content