Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Cme 4.1 problem conferencing on 7970

I have a new install cme 4.1. On the 7970 phone I was not able to do conferencing and not even able to hold and make a call on another line. Only one buttone configured. I have "dual-line" configured on the ephone-dn. The error I am getting is "no line avialable"

1 REPLY
New Member

Re: Cme 4.1 problem conferencing on 7970

The config shows dual line but when I look at it on the gui it says single. So i deleted the phone and reconfigured it with dual line and that took care of the problem.

106
Views
0
Helpful
1
Replies
CreatePlease to create content