Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CME 4.2 Meet-Me Conference issue

Hi,

I am in the process of setting up a meetme conference on a CME4.2 system, and despite following the admin guide and other guides referred to within other Netpro conversations, I just can't seem to get it to work.

Looking at the status of the dspfarm, the conference bridge appears to be in service, but if a user selects 'meetme' from their softkeys and dials the meetme ext (5194) they get a message on their phone advising 'no conference bridge'.

I've attached a copy of the running-config, and a capture of some show commands that might be of interest. Any help that could be offered would be greatly appreciated!

Thanks,

-Gordon

3 REPLIES
Hall of Fame Super Gold

Re: CME 4.2 Meet-Me Conference issue

Hi, you need to create more ephone-dn like the 35 you have already, up to the number of people that you want in conference, divided by two.

Also you need to so similarly for "ad-hoc" conferencing else once you set up "conference hardware", it will stop working.

Hope this helps, please rate post if it does!

New Member

Re: CME 4.2 Meet-Me Conference issue

Hi,

Thanks very much for the feedback. I've added some additional ephone-dn's now with the same number as ephone-dn 35. As soon as I have some feedback from the customer, I'll let you know whether it works.

Thanks again,

-Gordon

New Member

Re: CME 4.2 Meet-Me Conference issue

Hi,

Just to let you know that was it! It's all working now -thanks very much for your help.

Regards,

-Gordon

218
Views
0
Helpful
3
Replies
CreatePlease to create content