Hi I have a CME 4.3 router plus unity Express 3.1 system that is causing me some issues with my config when using COR. when i set the COR restictions on the Dial peers they work correctly and restict the calls to the correct destination - the issue that i am getting is that once the COR is applied it then stops the local phones on the system from calling each other on internal calls - but will allow an outgoing call that matches the COR list ie. to local area call.
found the problem my self after going back through the config - some of the users were in a different cor group with the same name applied as outgoing further down in the config - when i had tested the cor it was with these users - so in effect it was 2 differrent cor goups - so the call got blocked. Worked fine one i move all the users to "incoming" on the ephone-dn;s.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...