I have night service set up for the main line coming in. The bell rings and the users can pickup up the call with the gPickup softkey. No problem. However, if they want to transfer the call it's blind. I can't figure out how to transfer with consult. Also, when they've picked up one of these night service calls they can put the call on hold but they can't open a new call. The button simply does nothing. Any ideas? I've tried the following in telephony-service:
transfer-system full-consult dss
Is the pattern causing a problem? Do I need to somehow dedicate DSP resources to this? Is it even possible?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...