Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CME 7.0 Problems with meet-me "cannot complete conference"

Hello !


I have CME 7.0 in 2821 with  c2800nm-adventerprisek9-mz.124-20.T.bin, the following voice cards are included

VIC-4FXS/DID=
VWIC2-1MFT-T1/E1

The E1 card  is configured with just 10 trunks, a PVDM2-48 is includeed


I have been tried to config meet-me but when I dial meet-me number the following message is displayed
"cannot complete conference"

I don´t understand the reason of the message.

I attach the config related with meet-me,

if any of you can help me I would appreciate

regards

3 REPLIES

Re: CME 7.0 Problems with meet-me "cannot complete conference"

Hello,

Have you check if the DSP farm is register with CME?? with the "show sccp all" command you will be able to see that.

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Community Member

Re: CME 7.0 Problems with meet-me "cannot complete conference"

hi walter,

DSP farm are registered, I attach the results of sh dspfarm all and sh sccp all.

that's why I  don't understand the reason of the message

regards,

Community Member

Re: CME 7.0 Problems with meet-me "cannot complete conference"

Try first to remove the command "conference hardware" in the telephony service

656
Views
0
Helpful
3
Replies
CreatePlease to create content