Symptom: If customer configure the Max-ephone 100 under Telephony-system, the CME GUI only shows the ephone with ID that below 100. The CME GUI does not shows any ephone with ID that above 100. Notes, the ephone ID is not relevant with max-ephones configuration. Customer can assign any ID to ephone. The "max ephones" command should only limited the max ephone can be registered to the system. Conditions: Environment: CME: 7.1 GUI: 7.1 Workaround: Ensure the ephone ID is smaller than the value be configured in "max-ephones".
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...