Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME - 7936 does not have dial tone when you hit the phone button.

However, you can enter the number and hit "dial" and it works. This is CME 4.0.0(1) with 7936 phone load: cmterm_7936.3-3-5-0.bin.

Has anyone run into this issue with these versions? I'm trying to figure out whether if it's a hardware issue (my only 7936 at the site) or a phone load/CME version issue.

Thanks!

Mike.

2 REPLIES
New Member

Re: CME - 7936 does not have dial tone when you hit the phone bu

Sounds like a phone load issue. Check through the Release Notes on this Build of CME to see if you can "roll back" to a previous compatible 7936 phone load. I have ran into this with CME 3.4. Might still be issues with this 4.0?

Hall of Fame Super Gold

Re: CME - 7936 does not have dial tone when you hit the phone bu

I would first try upgrading to latest FW 3.3(13).

Release notes lists 40 bugs fixed. The bad news, is that there are 30 still open.

154
Views
0
Helpful
2
Replies