Have a 7940 phone that randomly locks up. Router is 3825 running 12.4(20)T.
Line one of the phone is a personal line with extension 101.
Line 2 is used to accept incoming calls for the facility (switchboard type use). Has an overlay of 7 numbers that are in 3 different hunt groups. (621, 622, 623, 626, 627, 628, and 631)
The hunt groups are used to add phones that ring the longer the call has been on the line. The first hunt group has three phones and rolls to the second group after 24 seconds. The second hunt group adds three phones that are ringing for 24 seconds. The third hunt group rings until answered.
Attached is a partial config with the relevant parts.
Line 2 has the box that shows up with call details, but has no text in it. If I remember correctly, the phone will not accept another call on line 2 while in this state.
The phone is unplugged to clear the line that locks up.
Has anybody run across anything like this or have any suggestions?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...