I have followed advice on previous posts by performing the following initial actions to fix the 7941 Phone displaying the wrong time. Interesting thing is that other 7941 phones are displaying correct time.
Verified phone type is correct in CME router.
username "XXXXXXX" password XXXX
Upgraded the ip phone firmware to a more current version -
One peculiar thing I noticed is that while other phones have the time zone specified (PDT) this problem phone does not.
Any advice as to what else to try would be greatly appreciated.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...