I had been having issues with making "url idle" changes to my configuration, resetting phones, and them not obtaining this configuration. I must have made the config change a couple dozen times. At some point, they 3 phones I have in my lab received the config change but when I removed it from my Unity installation, they KEPT loading the "url idle" long after it was no longer in my running or start-up configuration.
I rebooted the CME router. While the router was down I physically powered cycled the phones. Once everything was back up, the phones STILL had the "url idle" values configured! While in the SETTINGS of a particular phone, I typed *,*,#,*,* to unlock and choose "Erase" on the HTTP Configuration option. This removed all the entries, but now I can't get them to populate again with the fields I actually desire: Directory, Services, Authentication, etc.
I'm at a loss why my GUI and CLI changes to my "url" paramters are "sticking" on the phones, and not being downloaded to the phones upon a reset.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...