Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CME 7945 Issue No services Configured on EM

Hi,

I have an IP telephony setup running on CME version 9.1.I tried to configure the EM on the IP Phones.

CIPC is working fine with the EM.But when I tried to press in the globe button  in 7945 phone I am getting error like "No service Configured".

The Firm ware for the 7945 is SCCP 45.-9-3-1SR1-1S.

Please review the attached configuration for running config.  and TFTP bindings.

Thanks in advance......

Nithin Louis.

3 REPLIES
Green

CME 7945 Issue No services Configured on EM

Hi Nithin,

I can see a couple if issues fron your show run:-

1) ip http path flanh:

should be

ip http path flash:

2) For phones with firmware 9.x you need to add the folowing commands:-

!

telephony-service

service phone webAccess 0

!

Try these and retest

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
New Member

CME 7945 Issue No services Configured on EM

Hi Alex,

Thanks for your reply.

I tried ....but no luck.....still I am getting the same When I press the Globe button " No service Configured" .....

Regards,

Nithin Louis.

New Member

CME 7945 Issue No services Configured on EM

Hi ,

Any update guys.....?

Thanks & Regards

Nithin Louis.

333
Views
0
Helpful
3
Replies
CreatePlease to create content