Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME 79XX Web Access Enabled = No

How can I change the handset Web Access Enabled to YES with CME7.1 ?

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Re: CME 79XX Web Access Enabled = No

Hi

Good to hear..

Please help to identify useful content in the forums by marking questions as 'answered' if you have received a suitable response..

https://supportforums.cisco.com/docs/DOC-6212

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
5 REPLIES
Super Bronze

Re: CME 79XX Web Access Enabled = No

Hi

You can enable this for all phones like as follows (this will just insert the webAccess parameter into the vendor specific section of the XML config file the phones load as they boot - the webAccess bit will be case sensitive).

Telephony-service

Service phone webAccess 1

Create cnf-files

Then restart your phones...

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: CME 79XX Web Access Enabled = No

Yes, that work correctly.

Super Bronze

Re: CME 79XX Web Access Enabled = No

Hi

Good to hear..

Please help to identify useful content in the forums by marking questions as 'answered' if you have received a suitable response..

https://supportforums.cisco.com/docs/DOC-6212

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: CME 79XX Web Access Enabled = No

CME version 7.0.0

Had to change "service phone webAccess" value to "0" so = enable. "1" = disable.

Tested with "1" and it was disable on phones 7960 and 7962. Tried with latest firmware also (7960 at 8.1.2) (7962 at 9.0.2).

New Member

I have CME versin 8.8, 

I have CME versin 8.8, "service phone webAccess=0" command enabled Web Access, but 1 disables it.

6510
Views
40
Helpful
5
Replies
This widget could not be displayed.