cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
10124
Views
40
Helpful
5
Replies

CME 79XX Web Access Enabled = No

Gerald Chong
Level 1
Level 1

How can I change the handset Web Access Enabled to YES with CME7.1 ?

1 Accepted Solution

Accepted Solutions

Hi

Good to hear..

Please help to identify useful content in the forums by marking questions as 'answered' if you have received a suitable response..

https://supportforums.cisco.com/docs/DOC-6212

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

View solution in original post

5 Replies 5

Aaron Harrison
VIP Alumni
VIP Alumni

Hi

You can enable this for all phones like as follows (this will just insert the webAccess parameter into the vendor specific section of the XML config file the phones load as they boot - the webAccess bit will be case sensitive).

Telephony-service

Service phone webAccess 1

Create cnf-files

Then restart your phones...

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

Yes, that work correctly.

Hi

Good to hear..

Please help to identify useful content in the forums by marking questions as 'answered' if you have received a suitable response..

https://supportforums.cisco.com/docs/DOC-6212

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

rmartin001
Level 1
Level 1

CME version 7.0.0

Had to change "service phone webAccess" value to "0" so = enable. "1" = disable.

Tested with "1" and it was disable on phones 7960 and 7962. Tried with latest firmware also (7960 at 8.1.2) (7962 at 9.0.2).

I have CME versin 8.8, "service phone webAccess=0" command enabled Web Access, but 1 disables it.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: