At a client, they've got an older Avaya PBX that is connected into a 2900 router via PRI. From there, it gets routed across the network to another facility where they have a CME/CUE 8.5 system. When they dial an extension, it rings the phone no problem. But, if they try to call into CUE or into the Tcl AA/queue, it gives an error tone. When i watch the debugs on the router that is connected to the PBX via PRI, i see a message that says 'no route' (or something to that effect...). Does anyone have any ideas as to why regular calls work fine but when they go into CUE, it fails?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...