Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

CME 8.6 Auto registering IP Phone

Please let me know what are the basic command to enable AUTO-Register SCCP IP Phone in CME 8.6 in the DN range 3XX  ?

6 REPLIES
Cisco Employee

CME 8.6 Auto registering IP Phone

Bala,

Following document has a commands/ procedure to block auto-reg, so negation of that command should help you achieve what you want. Also I believe auto-reg is enabled by default in CME.

Checkout http://www.cisco.com/en/US/partner/docs/voice_ip_comm/cucme/admin/configuration/guide/cmesystm.html#wp1019342

GP.


Pls rate helpful posts !!

CME 8.6 Auto registering IP Phone

Thanks for the reply, how to mention the DN ranges for auto registration?

Cisco Employee

CME 8.6 Auto registering IP Phone

After enabling auto-reg, the DN range can be specified by command " Auto ". Syntax could be "Auto 3000-3400 ".

GP.

Pls rate helpful posts !!

New Member

CME 8.6 Auto registering IP Phone

Hi Bala,

            Under telephony-service you can give the command "auto-assign to "  , here the range that you are giving should be already configured for ephone-dns.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_a1ht.html#wp1117687

please rate helpful posts!!!

Regards,

Abdul Sattar

CME 8.6 Auto registering IP Phone

If we have 350 end point and  the internal number start from 3000 to 3250, in this case we need to manualy confiure 350 ephone-dn and then use auto-asign 1 to 350.

Is there is any way to specifiy the dn range and allow CME to auto register ?

Cisco Employee

CME 8.6 Auto registering IP Phone

Enable auto-registration using the command auto-reg-ephone, you don't need to manually configure any DNs

Your question about how to specify a range has already been answered by Abdul, you can refer to the command reference guide if you need more help, but he's telling you exactly how to enter the command to specify the DN range to be used.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesky

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
1353
Views
0
Helpful
6
Replies