11-10-2011 08:08 AM - edited 03-16-2019 07:59 AM
Hi
Network diagram is as below
[Abacus SIP UA]-------->[CME 8.6/Registrar]-------------SIP Trunk---------[Service Provider SIP Proxy]
Also attached NW diagram.
During outgoing call we get SIP error "500"
"Spirent Abacus system" is SIP User Agentt (Total 30 SIP clients are configured on Abacus)
These SIP UA is registered with Cisco CME 8.6.
There is SIP trunk between CME 8.6 and Service Provider SIP Proxy(product is ACME)
We have tested Outgoing call with Cisco SIP phones (79xx) registered on CME8.6 through SIP trunk.
Working perfectly.
But when we configure Abacus SIP UA with CME8.6, SIP UA registered with CME8.6, but outgoing calls are endingup with SIP error "500"
Here I have attached diagram, debug ccsip call/error output.
Pls. suggest.
Solved! Go to Solution.
11-10-2011 02:44 PM
Hi,
There's a Toll fraud security feature which I think is in your release which blocks SIP or H323 originating calls based on IP.
try adding:
voice service voip
ip address trusted list
ipv4 192.168.104.0 255.255.255.0
Adam
11-10-2011 02:44 PM
Hi,
There's a Toll fraud security feature which I think is in your release which blocks SIP or H323 originating calls based on IP.
try adding:
voice service voip
ip address trusted list
ipv4 192.168.104.0 255.255.255.0
Adam
11-13-2011 03:50 AM
Dear Adam
Thanks a lot. Your suggestion resolved the issue.
Rgds
Rajesh Kumar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: