Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME 8 install LOAD COMMAND ERROR:


Hello,

I am trying to setup cme 8 on a cisco 2801 running ios 15.1.T.

I have downloaded cme-basic-8.0.0.0.tar and cme-151-Tv2 on to flash.

I am going to use 7940 in the lab so I removed most of the other phone loads before extracting the file so that I could fit it in to the flash.

I have noticed that the "show flash" command shows the path as:

flash/P00308000500.sbn

The command "dir flash" command did not list the file.

So I copied it to the from the flash directory to flash so that it would be listed under the "dir flash:" command.

I have then added the files to router for the tftp-server:

tftp-server flash:/flash/os79xx.txt
tftp-server flash:/flash/P0S3-8-12-00.loads
tftp-server flash:/flash/P0S3-8-12-00.sb2
tftp-server flash:P003-8-12-00.sbn
tftp-server flash:P00308000500.loads
tftp-server flash:P00308000500.sb2
tftp-server flash:P00308000500.sbn
tftp-server flash:P00308000500.bin

I then proceed with telephony-service

CME_LAB(config-telephony)#load 7960-7940 P00308000500.sbn
LOAD COMMAND ERROR:cnf-file location system is not supported for creating automatic tftp bindings. Please use file location flash | slot0 | tftp OR create tftp bindings manually

ME_LAB(config-telephony)#load 7960-7940 P00308000500.bin
LOAD COMMAND ERROR:cnf-file location system is not supported for creating automatic tftp bindings. Please use file location flash | slot0 | tftp OR create tftp bindings manually

Weirdly is I add "]" at the end of the file extension it parses except for the .bin file

Any ideas on how to proceed?

If I try to create the cnf files it errors with

CME_LAB(config-telephony)#create cnf-files
Post-init cnf creation is in progress, pls re-issue this command later
CME_LAB(config-telephony)#

Also do I need a device license for cme 8.x as I am using it for lab purposes only?
Currently it says
License Info:

License UDI:

-------------------------------------------------
Device#   PID                   SN
-------------------------------------------------
*0        CISCO2801             FCZ0947117X

Configuration register is 0x2102

Thanks

Feisal

2 REPLIES
New Member

Re: CME 8 install LOAD COMMAND ERROR:

I have added the cnf location flash: command and that has got rid of the error.

LOAD COMMAND ERROR:cnf-file location system is not supported for creating automatic tftp bindings. Please use file location flash | slot0 | tftp OR create tftp bindings manually.

I get this error when creating the cnf-files, am I missing something. I haven't configured ntp yet but I don't think that should matter.

"Post-init cnf creation is in progress, pls re-issue this command later"

Thanks

Feisal

New Member

Re: CME 8 install LOAD COMMAND ERROR:

6283
Views
0
Helpful
2
Replies
CreatePlease login to create content