Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

CME ad-hoc conferencing

I understand that CME only supports 3-way conferencing. Where is the conferencing actually performed? I have a 2801 with a PVDM2-8 and have configured 8 channels on a fractional PRI. I do not have any spare DSP resources available on the router and have not configured conferencing yet I can do a 3-way conference from my IP Communicator phone. My question is, where is the conferencing actually performed? Is it performed on the phones utilizing the built-in conference bridge?

1 REPLY
Hall of Fame Super Silver

Re: CME ad-hoc conferencing

CME does not use the hardware conferencing, it only uses software conference bridge, bascially the phone itself is the conf bridge, hence only 3 participants.

Hardware resources on CME can only be used for voice channels and transcoding.

HTH,

Chris

259
Views
0
Helpful
1
Replies
CreatePlease to create content