Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME & analog phones

Hey i have an ATA186 connected to a CME. From any phone you are able to call the analog phone interfacing the ATA, but the outgoing call from the ATA doesn't work. I don't hear dial tones.

any ideas?

6 REPLIES
Hall of Fame Super Gold

Re: CME & analog phones

Hi,

which FW on the ATA ?

New Member

Re: CME & analog phones

the ata030100sccp04021.zup is loaded on the ATA

Hall of Fame Super Gold

Re: CME & analog phones

Hi, can you try ATA030203SCCP051201A ?

That's the latest and I use it without issues.

New Member

Re: CME & analog phones

i uploaded ATA030203SCCP051201A, it doesn't seem working though. I'm still facing the same problem, no outgoing calls-no dial tones.

Silver

Re: CME & analog phones

Did you ever figure this out? I have one out there behaving the same way, and I see we have the same starting load, and never get dial tone, but can receive calls on the phone, have two way audio - I just sent them to go find a plain old analog phone, because we were getting uneven results placing calls to the device with his butt set attached (sometimes gave busy when not off hook), but now I am nervous we have a bigger problem!

Mary Beth

Hall of Fame Super Gold

Re: CME & analog phones

Hi Mary,

No dial-tone is bad, can ultimately mean defective hardware. Anticipate the unit may need replacement.

129
Views
0
Helpful
6
Replies