I am trying to set up b-acd on my CME. I am running CME 4.1. When i go to the Cisco site to download the b-acd tar file i only see support for 4.0,3.4 and and 3.3. Can someone tell me which tar file to use?
As I'm configuring the b-acd application, each parameter I'm defining is giving me a X not registered under 'X service name' namespace. Is this reason for concern or should i just proceed with the configs.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...