All, Im starting my first CME today, and I received my router, with CME and CUE on it. Do I have to go and license it on Cisco's licensing website, for a key? OR Is it ready to just be configured and put in place without having to get a license. Im just thinking about Unity and CallManager in the past. Any thoughts?
You should be "good to go" here :) CME Licensing is honor based and there are no PAK registration requirements. As for CUE;
Installing Cisco Unity Express Software on a New System
Note: When you order Cisco Unity Express, Cisco Unity Express software and the purchased license are installed on the module at the factory. Spare modules also ship with the software and license installed.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...