Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME and discard 9

I've very new to CME/CUE and need some advice on part of my dial plan. I'm trying to implement dial "9" to dial out, but I find that my dial-peer is passing everything to the telco including the "9". Is there a command or a method that will allow me to discard it or to discard a pre-dot like in regular CallManager?

-Shikamaru

3 REPLIES
Hall of Fame Super Red

Re: CME and discard 9

Hi Shikamaru,

Here is what Cisco recommends in the CME SRND Guide;

!11-digit long-distance PSTN dialing with an access code of 9

dial-peer voice 1 pots

preference 1

destination-pattern 91..........

port 2/0:23

forward-digits 11

!

!7-digit local PSTN dialing with an access code of 9

dial-peer voice 4 pots

destination-pattern 9[2-9]......

port 2/0:23

forward-digits 7

From this good design doc;

Cisco Unified CallManager Express Solution Reference Network Design Guide

Cisco Unified CallManager Express Dial Plan

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_implementation_design_guide_chapter09186a00805f06ad.html

Hope this helps!

Rob

New Member

Re: CME and discard 9

Thanks for the reality check, Rob. Yeah, I stumbled into the world of "forward-digits" when I was doing some dial peer dubugging, good to see my mind was on the right track. I got the international dialing to work, now trying to figure out how the local dialing will go.

-Shikamaru

Hall of Fame Super Red

Re: CME and discard 9

Hi Shikamaru,

You are most welcome :)

Take care,

Rob

234
Views
0
Helpful
3
Replies
CreatePlease to create content