Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME and intermitant dial

Hi

We have a 2811 with CME on with 12.4.15 code on and two ISDN BRI lines. The problem we are experiencing is that outgoing calls are intermitantly working. This is not due to load as I'm the only one on these lines. I can use all four lines if I'm really lucky. What is strange though is that I can type in the number and hit dial and it IMMEDIATELY starts ringing. It does this sometime even when the BRIs are shut??? It doesn't give an enganged tone or anything, I get a sound like it's ringing on the other side. Then other times I hear a bit of delay and then I can see the call go out. Any thoughts, please. This is driving me nuts.

2 REPLIES
Anonymous
N/A

Re: CME and intermitant dial

Post the send 'show isdn status'.

New Member

Re: CME and intermitant dial

Thanks for the response. The problem ended up being a voice port that was actually a FXS port that was being used as a dial peer. The dial pattern was hunting between all the dial peers and thus it tried to phone out using a FXS every other time.

90
Views
0
Helpful
2
Replies