Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME AND TFTP ISSUE

The 7911 phones were connected to ccm before. Now I am trying to connect to cme

4.2 on router 2811.

I still noticed that the old configuration is avialable in phone settings.I reset the factory defaults since then phone is not able to load its firmware Please suggest the procedure

Thanks

1 REPLY
Bronze

Re: CME AND TFTP ISSUE

I did not see the proper config, but I am understanding the issue..

CME switch connected with CME router

On CME router, you have created the dhcp pool.

Are you connecting the phone on CME switch directly.

If yes, then I do not see any sub interface on CME router to pull the Vlan information

Please let me know if I understood the issue correctly!

128
Views
0
Helpful
1
Replies