All, I have a few questions that I need some help with. I am putting in a CUCM 7.x with a remote site having an 2911 for SRST. But the SRST function is supposed to be CME and not the traditional SRST that Im used to thinking of (as a MGCP gateway). I have this setup as an H323 gateway and have configured some of the srst config for CME, but I cant seem to get it to work. When I fail over the link between the sites, the phone just never registers with the CME. Any help appreciated.
Do you have SRST configured properly on the CUCM cluster? Do you have an SRST reference defined that points to the CME/SRST gateway and a Device Pool with that SRST reference in use by the phones at your remote site?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.