This issue has been resolved. For some reason, every video example I watched for basic SRST configuration involved deactivating the Callmanager service. I fixed the issue by accident when I was forced to reactivate the Callmanager service because I had to make a call between the Branches and CorpHQ. When I disabled the WAN interfaces
(which of course simulates an actual WAN outage) in lieu of disabling the Callmanager service, the error went away. This also enabled me to make a call from Branch1 running on SRST to Branch2 running on SRST on over the PSTN, however this is on a physical home lab. I believe on the INE lab rack you can only test one branch at a time.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...