Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CME + ATA 186 + FAX

At a customer site we have problems with incomplete faxes on a ATA186 (H323) and a CME. Anyone idea's?

Attached CME config + ATA config

1 REPLY
Hall of Fame Super Gold

Re: CME + ATA 186 + FAX

Hi,

Your config appears correct. Few things you could try

- specify codec g711u instead of A, even if you're in Europe

- try the values set the following doc:

http://www.cisco.com/en/US/partner/products/hw/gatecont/ps514/products_administration_guide_chapter09186a00800c4d1e.html

- Limit speed of you fax machines to 9600 or 7200 bps if possible.

I know it is not a consolation, but I have an installation where they hace incompete faxes going from FXS port to PRI. Go figure!

Hope this helps, if so please rate post!

259
Views
0
Helpful
1
Replies
CreatePlease to create content