CME B-ACD CLI Problem & Disconnect Problem using FXO!
I am from Riyadh Saudi Arabia. I am using:
1- Cisco 2801 CME Router
2- VIC2-2FXO Card
There are few problems that I am facing:
1- I am using B-ACD Script. The problem i am currently facing is that I have managed to get the CLI working on Cisco 2801 CME but when I use the B-ACD Script the CLI is not forwarded to the extensions. I can see the CLID if I debug the router but when the outside person dials an extension that the Incoming CLID is not forward to that extension. Is there any way to solve this issue? Any configuration?
2- As I am using the FXO cards on Cisco 2801, when someone calls and Hangup / Disconnect in the middle of the B-ACD script, the FXO Port is hanged and the call is not disconnected. Is there any way to resolve this issue or any configuration?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...