I have configured bacd on cme,inbound calls can reach aa,and input is working,but I cannot hear any prompts,even I try any audio files.
The cme is 2811 with ios 15.1(4)M8.
Below is my config.
application service aa flash:/cisco/its-CISCO.126.96.36.199.tcl param operator 8501 paramspace english language en paramspace english index 0 param queue-len 1 paramspace english location flash:/cisco/ paramspace english prefix en param aa-pilot 5153333 param welcome-prompt flash:/cisco/_welcome.au
dial-peer voice 91234 pots service aa destination-pattern .T incoming called-number 5153333 port 0/0/0:15
Router#dir flash:/cisco Directory of flash:/cisco/
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...