Ok, I understand better now, you want to set/reset CFA remotely.
I tried to write a TCL/IVR script to do that, but ran into a "limitation" for which HTTP POST operation from TCL/IVR cannot be authenticated. This is necessary for "reconfiguration" of the router by the script, and I couldn't come up with an alternate technique that doesn't require another SW module running on a server.
If cisco will ever fix the above, then it can be done.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...