Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME call forward all

Hi All,

We are using CME 4.2 version which is connected to SIP service provider. when I setup call forward all on IP phone and dial that IP phone, answering machine says "your call can't be completed as dial". but CME sends right digits based on "debug ccsip message" and "debug voice ccapi inout". I talked to SP and Cisco TAC, but the problem has not been solved yet.

these are the command I applied and related to this issue:

1- voice service voip

allow-connection sip to sip

2- telephony-service

call-forward pattern .T

any idea would be very appreciated.

thanks

Alex

2 REPLIES
Silver

Re: CME call forward all

Have you configured any new translation patterns recently? It may occur when a translation pattern has not been configured properly.

Also check whether the partition is correct and also check phone picked up the proper phone load

Re: CME call forward all

136
Views
0
Helpful
2
Replies