Is there a way to display the call park number on the ip phone after the call is parked for longer duration. Example Phone1 puts call from phone2 to call park, on phone1 it displays "call park at XXXX" this message is displayed for few seconds and then the default system message appears on the phone. How can we displayed the call parked at info for longder duration than default, thanks
Sorry to say there is currently no parameter/setting in CME to change this behaviour. This is a question that comes up fairly often, so I'm sure that the ability to change this will be in some future release. Here are 3 similar posts with no resolution.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...